6Gang30AmpsLatchRelayEspHomeReady
ESP32-S2 module based 6 Gang 30 Amps Latch Relay in DIN Rail enclosure. Best sutable for secure Home Automation, IOT.
Specification
- ESP32-S2 Matter ready chipset
- Embedded IPX to SMA adapter, 3dBi antenna, any SMA Wi-Fi antenna can be used.
- USB type C programming\debug connector, on board CP2102 USB-TTL converter
- 6 x 32 Amper Latch Relays, zero current idle consumption, suitable for any type of loads
- 32A terminals, 10-22AWG, 4mm2
- 6 x Optocoupled switch inputs
- 6 x Tact buttons + reset button
- 2 x Dallas temperature sensor pins with 5 kilohm pull up resistors
- 6 x status LED’s + 2 status LED’s
- High quality power supply, input voltage 85-305 Volts AC
- DIN rail plastic enclosure dimensions 150x106x42mm
- Board Dimensions 147x87mm
Installation
You can use the button below to install the pre-built firmware directly to your device via USB from the browser.
the button is visible from the 6Gang30AmpsLatchRelayEspHomeReady web page
Installation video
https://user-images.githubusercontent.com/18707133/182823948-121f1ef6-083b-4721-bfba-ffdc3a942aeb.mp4
To tweak the YAML code in 6Gang30AmpsLatchRelay.yaml and burn it into the board
-
follow instructions in the link below and install ESPHome Installing ESPHome Manually
-
compile and upload with command-line:
esphome run 6Gang30AmpsLatchRelay.yaml
Pin out:
| Latch Relays | Latch Relay ESP32-S2 pin # |
|---|---|
| Latch Relay 1 ON | 10 |
| Latch Relay 1 OFF | 9 |
| Latch Relay 2 ON | 20 |
| Latch Relay 2 OFF | 3 |
| Latch Relay 3 ON | 19 |
| Latch Relay 3 OFF | 8 |
| Latch Relay 4 ON | 15 |
| Latch Relay 4 OFF | 16 |
| Latch Relay 5 ON | 7 |
| Latch Relay 5 OFF | 6 |
| Latch Relay 6 ON | 5 |
| Latch Relay 6 OFF | 4 |
| Tact buttons | ESP32-S2 pin # |
|---|---|
| Button 1 | 11 |
| Button 2 | 12 |
| Button 3 | 13 |
| Button 4 | 14 |
| Button 5 | 21 |
| Button 6 | 33 |
| Optocoupled switch inputs | ESP32-S2 pin # |
|---|---|
| Switch 1 | 34 |
| Switch 2 | 35 |
| Switch 3 | 36 |
| Switch 4 | 37 |
| Switch 5 | 38 |
| Switch 6 | 39 |
| Dallas sensor ESP32-S2 pins: | ESP32-S2 pin # |
|---|---|
| Temp 1 | 40 |
| Temp 2 | 41 |
| i2c expander ESP32-S2 (LED’s pins): | ESP32-S2 pin # |
|---|---|
| SDA | 17 |
| SCL | 18 |